
techniques for seining
#1
Guest_dsaavedra_*
Posted 14 March 2009 - 10:52 AM
with the weather warming up i want to know how to use it.
its a 4x8' seine, and 5 foot sections of 1" PVC pipe as the handles.
so are there any techniques i should know when i go to use my seine?
#2
Guest_CATfishTONY_*
Posted 14 March 2009 - 11:56 AM
find 2 friends and get the net wet.i got a seine a little while ago but i know nothing about it.
with the weather warming up i want to know how to use it.
its a 4x8' seine, and 5 foot sections of 1" PVC pipe as the handles.
so are there any techniques i should know when i go to use my seine?
place it just below a riffle and have a pall walk to you kicking the rocks and sand around thats it.
have fun.
you may need to change the 1"pvc it may be to limp
#6
Guest_Uland_*
Posted 14 March 2009 - 03:20 PM
would it be practical to use a seine in a pond? because there aren't really a lot of big streams around here.
I really avoid big streams at this time of year. If you can, seek the smaller stream especially when starting out. You can easily learn what fish live where and more completely sample all types of structure.
#8
Posted 14 March 2009 - 03:53 PM
Arent there any restrictions on seining, other than a valid fishing license??
Sure there are... and they vary greatly from state to state... seine length... seine mesh size... where you can seine (some streams down here are designated no seine trout streams... or maybe what time of year you can seine... and of course what fish can be kept... look at your fishing regulations, they usually have something about seining for "bait fish" (again, these are defined differently in each state)... you want to know what you can keep and what you have to put back... but even what you put back can be quickly photo'd...
#9
Guest_fundulus_*
Posted 14 March 2009 - 04:56 PM
#10
Guest_smilingfrog_*
Posted 14 March 2009 - 05:16 PM
would it be practical to use a seine in a pond? because there aren't really a lot of big streams around here.
If you can get about 3-5 friends along with you a seine can be quite effective in a pond. Wade out single file to about 3.5 feet, then spread out the seine. Angle it so that the bottom is forward. Have the extra friends (those not holding the seine) off to the side and a little in front of the seine. Then run it in towards shore as fast as you can while keeping the bottom of the seine against the bottom of the pond (it won't be very fast

I would second changing out the PVC. I doubt it would hold up to this kind of treatment. You will be amazed at how much pressure is generated by dragging a seine through the water.
#11
Guest_dsaavedra_*
Posted 18 March 2009 - 05:50 PM
#12
Guest_CATfishTONY_*
Posted 18 March 2009 - 06:04 PM
sounds like you need a one man net.i have a feeling this seine isn't going to see much action because it seems like it will be difficult to use around here (there are no hard bottoms, all silt, very difficult to walk in) and i only have one friend that would be willing to go seining with me.
http://www.memphisne...egory/nets_cast
#14
Guest_dsaavedra_*
Posted 20 March 2009 - 02:29 PM
Dave,
You might be better off with a good deep dipnet for your areas. You could use a 4' wide seine by yourself but most of the places by you are full of so much detritus, muck, silt, and wood you'd just ruin it.
i was starting to think the same thing.
#15
Guest_factnfiction101_*
Posted 20 March 2009 - 08:13 PM
The problem with it was that the seine net was old, so it got holes in it after catching a few rocks

#16
Guest_PhilipKukulski_*
Posted 21 March 2009 - 09:01 AM
To fix any hole:
Loop a piece of dental floss and tie a regular knot. Cut off the excess on both ends, saving one piece for the next knot. Repeat many times.
Edited by PhilipKukulski, 21 March 2009 - 09:03 AM.
#17
Guest_factnfiction101_*
Posted 22 March 2009 - 12:51 AM
I used 50 lbs. test line for my casting net, in my topic. For the inside line that pulls it shut. I use 10 lbs. test to sew it, and 30 lbs. test for adding extra sinkers to it. I had to add weight to it because a seine net sinks a little slower than a normal casting net.
Never thought of using dental floss, why would you use that instead of regular fishing line? Sorry to get off subject...
Reply to this topic

1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users